Your Satisfaction is our Destination


FBA CAR Denting & Painting

We provide quality denting services. With our state-of-the-art Authorized & Multibrand service stations and machines, we ensure to provide excellent denting & painting services to our clients. We also undertake complete denting & painting solutions and provide our customers an exhaustive repair for cars, for a complete car servicing experience to our clients.

5 Steps to DENT REPAIR

Step 1 - Remove The Dent

Gain access to the reverse of the body panel by removing items such as interior trims and door panels.
For more serious dents, first use a Dent Puller to pull out the damaged area.
Use a Hammer & Dolly to tap the dent out as close as possible to the original panel line.
Be sure not to tap the dent out higher than the panel line, leaving enough room for Body Filler.

Step 2 - Surface Preparation

Before you can fill the dent you need to remove the paint, as Body Filler doesn’t stick well to paint.
  • Use an abrasive pad or 36-40 grit speed file paper to remove all paint from the dent and surrounding area.
  • Clean the area with a Prepwash Wax and Grease Remover.
  • Treat any evident rusted metal with a Rust Converter.

Step 3 - Apply Filler

  • Mix the required amount of body filler with a hardener until a uniform mixture is obtained.
  • Apply Body Filler with an applicator to cover dented area.
  • Be sure to work the Body Filler outside the dent as well as into the crease so there is enough material to feather back once sanding begins
  • Allow to cure for approximately 20-30 minutes.

Step 4 - Shape & Sand

  • Carefully sand back until the filler is level with the surrounding panel.
  • For the best results begin with a course grit speed file paper and work up to a 120 grit sandpaper.
  • You may find that larger dents require several applications of filler or spot putty before a good surface is achieved

Step 5 - Finishing

  • Ensure you clean all surfaces with a wax & grease remover before you begin any painting.
  • Mask surrounding areas with Masking Tape to avoid overspray.
  • Apply a Surface Primer or Primer Putty to fill any sanding marks remaining in the repair.
  • Spray a coat of Etch Primer and sand back using wet and dry sandpaper to remove scratches.
  • Clean the surface again with Prepwash and wipe dry with a clean cloth.
  • Apply 2 to 3 coats of your selected Acrylic Basecoat Colour to the repaired area allowing 10 minutes between coats.
  • Once the basecoat is dried, thoroughly apply Clear Top Coat as required and let it flash dry for 5 minutes before applying additional coats.
  • For the best result it may require a light sand with 2000 grit wet and dry paper and a final polish.

Send Us Your Feedback

FBA Building 2nd Floor, Rua Delta III , Comoro Dili , Timor Leste

E-mail –, Phone +67078742970

FBA WISP webmail